KX11 PHEV 2023 2-40 Engine control system (DHE15-ESZ) Engine 1 Install the differential filter pressure sensor and tighten the fixing bolts 2 of the differential filter pressure sensor. Torque: 10N·m Caution 1. Electrostatic protection: storage, transportation and assembly process shall have electrostatic protection measures, prohibit contact with the sensor pins. 2. Do not allow electrified plugging and unplugging of the sensor connector during the energized operation such as cold or hot testing. 3. Avoid dropping parts or subjecting them to shocks. Dropped parts must be scrapped. 4.
Insert the high-pressure connector of the differential pressure sensor 2 into the connector of the hose at the high-pressure end of the differential pressure sensor to the end, align the marks. 5. Apply an appropriate amount of a similar P80 insertion aid to the orifice of the differential pressure sensor before installation, and prohibit the use of oil and other oily substances as insertion aids. 2 Connect the differential pressure filter pressure sensor harness connector A. 3 Connect the differential pressure filter pressure sensor to the rubber tube, and install the differential pressure filter pressure sensor to the rubber tub fixing clamp 1. 4 Connect the negative cable of battery.
5 Use the GLDS diagnostic program. On the [Software] tab, select the corresponding module and follow the steps prompted by the diagnostic program to complete the software flash operation. 2.2.6.11 Replacement of Engine Control Module 6 Close the engine compartment cover. Removal Procedure Warning ！ Refer to "Warnings regarding battery disconnection" in " Warnings and Precautions ". 1 Open the engine compartment hood.