6th TEMP_EXTREMELY_LOW 16th FAILS_ENERGY_CALIBRATION Bit Meaning Bit Meaning 7th TEMP_TOO_HIGH 17th EMPTY_DUMMY 8th TEMP_TOO_LOW 18th FULL_DUMMY 9th BAD_ACUMEN_INFO 19th END_OF_LIFE 10th NO_PEN 20th OUT_OF_WARRANTY The binary number needs to be read from right to left so that the 1st bit corresponds to the right one of the binary number. For example, the error code 4099 is converted to binary number 10000000000011. So using the table above, the error code means “FAILS_LOGICAL_V”, “FAILS_CONTINUITY” and “MISMATCH”. Carriage Interconnect Wiper NOTE: The Carriage Interconnect Wiper is part of the Maintenance Kit.
All the instructions needed to use the Carriage Interconnect Wiper will be packaged with the kit. Whenever you replace the Printhead, check the empty slots to see if they need cleaning. In extreme circumstances, when a Printhead is inserted, it is possible that the Printer will not recognize it due to the build-up of ink on the electrical connection between the Printhead and the Carriage Assembly. Ink Supplies Included with the HP Designjet Printer, is a Carriage Interconnect Wiper. This tool is provided in a separate package. It also contains replacement sponges and an instruction sheet.
This tool should be used for cleaning the electrical interconnects of both the Carriage Assembly and the Printhead. If the front panel displays the message “Reseat” or “Replace” next to the offending printhead, try cleaning the flex circuits of the Carriage and the Printheads. CAUTION: Do not touch, wipe or attempt to clean the printhead nozzles. This can damage the printhead and reduce print quality. Warranty Information for Ink Supplies Ink Cartridge The warranty for the Ink Cartridges will end when one of the following occurs: • 30 months from the date of manufacture or • When the advertised deliverable ink has been reached Carriage Interconnect Wiper 91