If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. • Checking voltage. If there is a failure at this point, the Front Panel will display System Error Code 03:10 . For more information on troubleshooting this error code, refer to page 48. Check also System Error Code 01.0:10 (refer to page 47). • Clear GPIO psu_lpm. If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. • Checking voltage.
If there is a failure at this point, the Front Panel will display System Error Code 03:10 . For more information on troubleshooting this error code, refer to page 48. Check also System Error Code 01.0:10 (refer to page 47). • Config GPIO drv_enable. If there is a failure at this point, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. 3. After initializing the Scan-Axis system, the following message will appear on the Front Panel. 4. Open the Window, position your head as close as possible to the platen in order to check if the Carriage power light is ON (a very dim green light on the carriage PCA).
Select Yes or No by using the Up and Down keys and press Enter to confirm your selection. Tests and Utilities NOTE: To be able to see the LED, you have to place your head very close to the Platen but if you are not comfortable doing that you should remove the Right Cover before starting the test. If you select No at this point, the Front Panel will display System Error Code 02.1:10 . For more information on troubleshooting this error code, refer to page 48. Check also System Error Code 11:10 (refer to page 51) or System Error Code 07:10 (refer to page 50). If you select Yes , then the Front Panel will display: • Booting up the Carriage.
If there is a failure at this point, the Front Panel will display System Error Code 02.1:10 . For more information on troubleshooting this error code, refer to page 48. Check also System Error Code 11:10 (refer to page 51) or System Error Code 01.1:10 (refer to page 47). 98 Chapter 4 Service Tests and Utilities