2. A message will appear on the Front Panel asking whether you would like to check the APS. Select Yes or No by using the Up and Down keys and press Enter to confirm your selection. If you select No , the printer skips this test and goes to the next one: 3. A message will appear on the Front Panel asking you to insert all the Ink Cartridges. Insert all the Ink Cartridges and press any key to continue: 4. The Printer will initialize the APS and the Front Panel will display the following messages: • Starting Nvm. • Starting Cds. If there is a failure at this point, the Front Panel will display System Error Code 79:03 . For more information on troubleshooting this error code, refer to page 72.
• Starting Sausalito. If there is a failure starting the Sausalito, the Front Panel will display System Error Code 01.0:10 . For more information on troubleshooting this error code, refer to page 47. • Starting SuppliesConf. If there is a failure starting the SuppliesConf, the Front Panel will display System Error Code XX.X:XX . For more information on troubleshooting this error code, refer to page 47. • Starting Pump. Tests and Utilities If there is a failure starting the Pump, the Front Panel will display System Error Code XX.X:XX . For more information on troubleshooting this error code, refer to page 47. 5.
The Printer will pressurize the APS and the Front Panel will display the following messages: • Pressurizing. Followed by the actual pressure as the APS pressurizes. • Holding Pressure. Followed by the actual pressure being held. • Depressurizing. If there is a failure starting the Pump, the Front Panel will display System Error Code XX.X:XX . For more information on troubleshooting this error code, refer to page 47. 6. IOnce the test is completed, OK will be displayed on the Front Panel. 9. Vacuum Fans Test The purpose of this test is to verify the operation of the Vacuum Fans. Entering the Service Tests Menu 117