2. The Printer checks to see if media is loaded. If media is loaded, the Front Panel will display the following message. Unload the media and start again from step 1 : 3. The Drive Roller begins to turn slowly and the following message is displayed on the Front Panel: 4. Refer to the Cleaning Instructions on page 452. 5. Once you have finished cleaning the Drive Roller and the Overdrive, press the Cancel key to finish the utility. 6. If the utility exits correctly, OK will be displayed on the Front Panel. NOTE: PLEASE REMEMBER TO REMOVE THE PIECE OF PAPER FROM THE WINDOW SENSOR BEFORE CLOSING THE WINDOW AS THIS COULD DAMAGE THE WINDOW AND THE SENSOR. 2.
Prime Tubes The purpose of this Service Utility is to Prime the Tubes when the Ink Tubes are NOT new and they need to be re-primed or automatic priming was not completed correctly. Tests and Utilities NOTE: Make sure that NEW Ink Cartridges are installed or that the ink volume remaining in the Ink cartridges is below 88% before starting to prime the tubes. If you do not comply, you will get a warning message. Perform the Prime Tubes utility as follows: 1. In the Service Utilities submenu, scroll to “Prime Tubes” and press Enter . Service Utilities 135