Troublshooting a failure with the Take UP Reel (TUR) Troubleshooting Use this section to troubleshoot failures with the TakeUP Reel. Take Up Reel LED status information LED status Issue Print job interupted Possible cause Print job interrupted? Blinking quickly Take Up Reel not winding Yes Sensor beam blocked for more than 3 seconds Ensure the Take Up Reel sensors are not blocked by a strip of paper, the collection bin or other objects. Also ensure the Take Up Reel power switch is in the On posi- tion. Blinking slowly Take Up Reel not winding No The sensor cables are loose or unplugged Ensure the sensor cables are cor- rectly connected.
Solid red Take Up Reel not winding No There is too much resis- tance on the Take Up Reel motor ENSURE THAT THE TUR Spindle Lever is CLOSED! Ensure the paper is not winding too tightly. A loop-shaping core should be inserted and hanging down. Solid green Take Up Reel not winding No The Take Up Reel power switch is in the Off posi- tion Ensure the Take Up Reel power switch is in the On position. Solid green Take Up Reel winding in the wrong direc- tion, and not stoppinjg the job. No The Take Up Reel wind direction switch is in the wrong winding position. after 3 seconds, the printer will recognize the problem and interupt the print job. In this case, see the first error listed in this table.
Flip the Take Up Reel wind-direc- tion switch to the correct posi- tion. NOTE: If the LED is flashing but there is no message on the front panel, restart the printer. Troublshooting a failure with the Take UP Reel (TUR) 9