Rear Door (42-inch) Removal WARNING!: Switch off the printer and remove the power cable. NOTE: Throughout this section the graphics actually show the HP Designjet 4000 Printer series but the steps of the procedure are identical for the HP Designjet Z6000 Printer series. 1. Remove three T-15 screws ( Type G ) from the Rear Door. NOTE: Each screw includes a washer (part number 3050-1267). Removal & Installation 2. Open the Rear Door slightly (as shown). 3. To release the right hand hinge of the Rear Door, move the Rear Door to the right (1) and towards you (2). 1 2 Rear Door (42-inch) 281