13. Lower then lift the Vacuum Fan out of its attachment. 1 2 14. Remove the Vacuum Fan from the Printer. Removal & Installation NOTE: When connecting the Vacuum Fan cables to the Interconnect PCA, make sure you connect the cable with the label marked Vacuum Fan 1 to connector 1 and the cable with the label marked Vacuum Fan 2 to connector 2. You can verify if both cables are labelled correctly by the actual markings on the Vacuum Fan. Cable 2 NOTE: Make sure that the OMAS ribbon cable is free of slack when you install the cable clamp. Cable 1 NOTE: After installing the NEW Vacuum Fan, make sure you perform the following Service Calibration: • Paper Advance Calibration ⇒ Chapter 5.
306 Chapter 8 Removal & Installation