6. Carefully pull the OMAS Cable back into the Vacuum Beam (from the Service Station end) until the straight fold immediately before the first diagonal fold (from the OMAS sensor end) is aligned with the slot, fold the OMAS Cable across the diagonal fold, and install the cable clamp to lock the OMAS Cable in the correct position. 7. Route the OMAS Cable to the Ferrite Core in the Right Interconnect panel. Removal & Installation 8. Feed the OMAS Cable through Ferrite Core. 9. Connect the OMAS Cable to the OMAS Controller Card with the connections on the top. 368 Chapter 8 Removal & Installation