Corrective Action: Try the following: • Remove the Printheads and check that they are the correct ones for this Printer. • Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest version. • Replace the Printheads. System Error: System Error Codes 29:02 Problem Description: The maintenance cartridge absorber is almost full. It will have to be replaced soon. Corrective Action: Try the following: • Replace the Maintenece Cartridge. • If the message persisits even though the Maintenance Cartridge has been replaced but the printer incorrectly detects that the cartridge is old, check that the Printer has the latest Firmware version.
If not, update the Firmware to the latest version. • Clean the Encoder Strip using a lint free cloth dampened with tap water, then reset the counter (Setup > Resets > Encoder cleaning) ⇒ See the instructions provided in the User Maintenance Kit and ⇒ Page 454 • If the new Maintenance Cartridge is not detected, reset the life counter of the part manually ⇒ Page 138. System Error: 32:01.1 Problem Description: This system error occurrs when there is a small amount of paper printed (less than 79 inches (200cm) long. Corrective Action: Try the following: • Check there is no obstacle between the Take-up reel optical sensors. • Check the paper is attached to the TUR spindle.
• Check the TUR switch is in the correct position. • If needed, use the TUR arrow keys to wind paper before resume printing. • To resume printing, press OK. System Error 32:01.2 Problem Description: This system error happens when there is a small amount of paper printed (less than 70 inches long), and the Take Up Reel sensor detects that the loop shaper is (incorrectly) at the bottom of its path, even though the spindle motor has been rotating for more that 3 seconds. 58 Chapter 2 System Error Codes