19207-12472301 Revision A Page 9 of 123 Downloaded from https://www.everyspec.com LIST OF TABLES Table P.1 Weld Specification Cross Reference Matrix.....................................................................................4 1.1 Aluminum Alloy Products Available for Structural Applications .....................................................14 1.2 Recommended Aluminum Alloy Filler Metals for Structural Welding of Various Aluminum Alloys..............................................................................................................................................15 3.1 Limit of Acceptability and Repair of Cut Edge Discontinuities in Plate ..........................................20 4.1 Typical Current Ranges for Tungsten Electrodes..........................................................................27 4.2 Typical Chemical Composition of Tungsten Electrodes ................................................................28 5.1 Tensile Strength of Welded Aluminum Alloys (GTAW or GMAW With No Postweld Heat Treatment)......................................................................................................................................40 5.2 Procedure Qualification - Type and Position Limitations ...............................................................50 5.3 Number and Type of Test Specimens and Range of Thickness Qualified — Procedure Qualification; Complete Joint Penetration Groove Welds..............................................................52 5.4 Number and Type of Test Specimens and Range of Thickness Qualified—Procedure Qualification; Partial Joint Penetration Groove Welds ...................................................................54 5.5 Number and Type of Test Specimens and Range of Thickness Qualified —Procedure Qualification Fillet Welds................................................................................................................57 5.6 Welder Performance Qualification—Type of Weld and Position Limitations.................................58 5.7 Number and Type of Test Specimens and Range of Thickness Qualified Welder and Welding Operator Qualification ......................................................................................................64 6.1 Penetrameter Requirements..........................................................................................................70 7.1 Minimum Fillet Weld Size for Small Diameter Studs......................................................................76 7.2 Minimum Required Torque Values and Tension Loads for Arc Stud Welding (F-22 Aluminum Alloy Studs) .........................................................................................................77 7.3 Minimum Required Torque Values and Tension Loads for Capacitor Discharge Stud Welding (F-22 Aluminum Alloy Studs) ...........................................................................................80 9.1 Maximum Acceptable Porosity in Radiographs for Any 3 in.
Length of Weld (Dynamically Loaded).....................................................................................................................89 10.1 Sample Inspection Frequency Table..............................................................................................95 10.2 “Consecutives” Table for Random Positions..................................................................................95 10.3 Striking Velocity Requirements for 5083 Aluminum Alloy Using the 75 mm Aluminum M1002A Plate Proofing Projectile ..................................................................................................97 10.4 Striking Velocity Requirements for 7039 Aluminum Alloy Using the 75-mm Aluminum, M1002A Plate Proofing Projectile ..................................................................................................97 10.5 Striking Velocity Requirements for 5083 Aluminum Alloy Using the 57-mm Aluminum M1001A Plate Proofing Projectile ..................................................................................................97 10.6 Striking Velocity Requirements for 7039 Aluminum Alloy Using the 57-MM Aluminum M1001A Plate Proofing Projectile ..................................................................................................97 10.7 Striking Velocity Requirements for 2519 Alloy Aluminum Armor Weldments Using the 75-mm, M1002A Aluminum Plate Proofing Projectile....................................................................97 Status:
RELEASED Date: 6/3/03