Hantek 6022BE Input a signal to a channel of the oscilloscope The oscilloscope is equipped with dual channels. Please input signal in the following steps: Set the attenuation switch on the probe as 10X and connect the probe on the oscilloscope with CH1. Aim the slot in the probe connector at the faucet on BNC of CH1 and insert, then, turn right to lock the probe. Finally, attach the tip of probe and ground nip to the Connector of Probe compensator. 1. Set the CH1 probe attenuation of the oscilloscope to X10. (The default is X1). 2. Attach the tip of probe and ground nip to the Connector of Probe compensator. A square wave will be displayed within a several seconds.
(Approximately 1 kHz, 2V, peak- to- peak). 3. Inspect CH2 with the same method. Repeat steps 2 and 3. User’s Manual 14