Hantek 6022BE Auto : Acquire waveform even no trigger occurred Normal : Acquire waveform when trigger occurred. Single : Acquire waveform when trigger occurred then stop Source: You can use the trigger source options to select the signal that the oscilloscope uses as a trigger. CH1 : Select CH1 as trigger signal CH2 : Select CH2 as trigger signal Slope: Set the slope to Rising (+) or Falling (-) . Rising : Trigger on rising edge Falling : Trigger on falling edge 3.5 Measure Signal 3.5.1 Cursor Click “ Cursor ” in main menu. This method allows you to take measurements by moving the cursors 1. Source The user can set the source to CH1 , CH2. User’s Manual 32