Hantek 6000EU Digital Oscilloscope 2.1 The User’s Interface Click the software icon on the desk after you finished the software setting and equipment connecting. Then a user interface will be showed as follows: In addition to displaying waveforms, the display area is filled with many details about the waveform and the oscilloscope control settings. 1. The Main Menu: All settings can be found in the main menu. 2. The Toolbar 3. Displays the trigger information: Displays the edge trigger slope, source and level. 4. The Connect Panel 5. The Horizontal Panel: The user can change Time/Div, format in the panel. 6. The Vertical Panel: The user can turn on/off the CH1/CH2/CH3/CH4.
Also the user can change the CH1/ CH2/CH3/CH4 volt/div, coupling and probe attenuation. 7. The Trigger Panel: In this panel, the user can change the trigger mode, sweep, source and slope. 8. Marker shows Edge trigger level USER’S MANUAL 17