1. Press the power key to start the instrument. 2. Press the [AUTO/R/C/L/Z] key until Ls/Lp is displayed on the interface which means to select inductance measurement. 3. Insert the inductor into the test notch, or choose the appropriate test accessories (rubber plug - alligator clip, Kelvin test fixture, etc.) and connect it with the measured inductor. 4. Press the [FREQ] key to select the desired test frequency, press [LEVEL] to select the desired level. 5. Read the measurement results from the screen. 3.4 Impedance measurement 1. Press the power key to start the instrument. 2. Press the [AUTO/R/C/L/Z] key until Z is displayed on the interface which means to select impedance measurement.
3. Insert the impeder into the test notch, or choose the appropriate test accessories (rubber plug - alligator clip, Kelvin test fixture, etc.) and connect it with the measured impeder. 4. Press the [FREQ] key to select the desired test frequency, press [LEVEL] to select the desired level. 5. Read the measurement results from the screen. 17