Start using CN 8 Start using ⚫ To prevent electric shock accidents, please do not short circuit the top of the test line and the line with voltage. ⚫ Do not measure AC voltage, AC current, or DC current. Otherwise, it may cause instrument damage or personal injury accidents. ⚫ To prevent electric shock, please confirm the rated value of the test wire before measurement, and do not measure voltage higher than the rated value. 8.1 Measurement Settings Click the [Range] button to enter the measurement display interface. Click the Type menu soft key to select categories such as V&R, Voltage, and Resistance.
8.2 Set voltage range 1 Press the [Range] key to enter the measurement page； 2 Click on the Range (V) menu soft key； 3 Use the menu soft key to select the range and complete the voltage range setting. 8.3 Setting the Resistance Range 1 Press the [Range] key to enter the measurement page； 2 Click on the Range (R) menu soft key; 3 Use the menu soft key to select the range and complete the setting of the resistance range.