Quick start EN 4.4 Product Introduction This chapter describes the front and rear panels and user interface of the machine. 4.4.1 Front Panel Figure 4.3 Front Panel 1. On/Off Switch 2. Menu Softkey Correspond to the left menus respectively. Press any softkey to activate the corresponding menu. 3. Function Keys ⚫ [Wave]: Select the waveform that the current channel will output. ⚫ [Setting]: Set the parameters of the waveform that the current channel will ⚫ [Utility]: Auxiliary functions and system Settings. Used to set auxiliary function output. and system parameters. ⚫ [Mod]: Enable generate modulated waveforms.
A variety of analog and digital modulation methods are provided to generate AM, DSB-AM, FM, PM, ASK, FSK, PSK, BPSK, QPSK, 3FSK, 4FSK, OSK and PWM modulation signals. ⚫ [Sweep]: Enable generate sweep signals of "sine", "square", "ramp", "pulse", "harmonic" and "arbitrary (except DC)". ⚫ [Burst]: Enable generate burst signals of "sine", "square", "ramp", "pulse", ⚫ [Trigger]: Manually triggered button. In sweep or burst mode, used to manually "harmonic" and "arbitrary (except DC)". trigger CH1 or CH2 to produce a sweep or burst signal (only when 1Output or 2Output is turned on). ⚫ [CH1/2]: Channel switching. Press this button to switch menu setting channel.
After selecting CH1, users can set the waveforms, parameters, and configuration of CH1. HDG3000B User manual Copyright © Qingdao Hantek Electronics Co., LTD 12