Command system EN ⚫ The burst mode cannot be enabled when scan or arbitrary modulation mode is enabled. When burst is enabled, scan or modulation mode will be turned off. Return format ON or OFF. For example, SOURce1:BURSt ON /* Turn on the burst output function of channel 1 */ 3.5.5 SOURce :BURSt:TRIGger:SLOPe Command format SOURce :BURSt:TRIGger:SLOPe POSitive|NEGative SOURce :BURSt:TRIGger:SLOPe? Function description Select the signal generator to start the sweep output when the rising edge (POSitive) or falling edge (NEGative) of the signal is triggered externally. Argument Instructions None Return format Returns the keyword of the current triggered source slope.
Example SOURce :BURSt:TRIGger:SLOPe NEGative /* Set the sweep output from the time when the trigger source of channel 1 in scan mode is falling edge */ 3.5.6 SOURce :BURSt:TRIGger Command format SOURce :BURSt:TRIGger Function description Make the instrument trigger immediately. Copyright © Qingdao Hantek Electronics Co., LTD HDG300C Programming manual 19 Name Range Default value SLOPe POSitive|NEGative POSitive