Step 2: Press [Cont] on the front panel to open a menu. You can use this menu to choose to use buzzer or disable buzzer. The continuous measurement method is as follows: The diode This section describes how to configure diode tests on the front panel. Step 1: Configure the test leads, as shown below. Step 2: Press the one on the front panel to open a menu which specifies whether the DMM will ring to indicate a successful diode test. 39 ≤ 10 Ω Display measured resistance and buzzer (if buzzer is enabled.) 10 Ω to 1.2 k Display measured resistance, no buzzing > 1.2 k Ω Display OPEN, no buzzing