Quick Guide 4. Remote control 4.1 USB remote control Use the USB cable to connect the USB port on the back of the computer to the USB port on the rear panel of the power supply. At this time, the USB connected logo is displayed on the upper right corner of the main interface of the power supply. Download and install the IO software from the following address: https://www.keysight.com/main/software.jspx?id=2175637&nid=-11143.0.00&pageMode= CV&lc=eng&cc=CA Open the IO software, find the device, and send an instruction to see if the communication is normal. After normal communication is obtained, SCPI commands can be used to control the power output. E.g:
OUTP On, (@1) Set the channel 1 output on. Volt 5, (@1) Set the voltage of channel 1 to 5V. Meas:volt? (@1) View the output voltage value of channel 1. 17