Connect the drain hose Make sure the drain hose is attached by pushing the end of the drain hose onto the barbed connection on the back panel of the system. Secure the hose with the hose clamp using a flat bladed screwdriver. Route the free end of the drain hose to the wastewater location. Make sure the system is at least 20 cm (8 in.) above the drain hose discharge and there are no kinks in the hose. The system relies on gravity to drain the wastewater from the cleaning tank. Figure 2: Drain hose connections Connect the water hose Screw on the end of the water supply hose to the back panel of the system. Securely tighten the fitting clockwise.
Turn on the water and make sure there are no leaks. Figure 3: Water hose connections Plug in the system Securely plug one end of the supplied power cord into the receptacle at the back of the system and the other end of the power cord into a grounded receptacle. Only use the power cord provided. 10