20 Problem Recommendation Replacement Parts * Part most likely to resolve issue ** Part less likely to resolve issue Water has not fully drained from the cleaning tank assembly Verify that the strainer and cleaning tank drain are not clogged. Verify that the drain hose is not clogged. Verify that there are no kinks in the drain hoses. Make sure the system is at least 20 cm (8 in.) above the drain hose discharge. Make sure that no section of the drain hose is higher than the system discharge. Verify that the power cord is securely plugged in. Verify that the power switch is in the ON position. Verify that AC power is present at the power outlet.
Models not clean Make sure all the contents of the speci- fied number of cleaning agent bag(s) is used. * Agitation drive belt ** Induction motor ** Agitation assembly ** Cleaning tank assembly Make sure the correct cleaning tank assembly level is selected. Make sure the correct cycle length is selected. Repeat the cleaning cycle. Make sure the model basket is used to submerge models in the cleaning solu- tion and the correct system lid position is selected. Cleaning tank assembly not heating. Note: Verify that the tank has failed to heat before replacing the cleaning tank assembly, by touching the tank during unit operation.
The system is leaking Verify that the inlet and drain hose connections are tight. Yellow flashing process error LED Open and close the system lid and then make sure the lid is fully closed. * System lid ** System lid sensor ** Cleaning tank assembly If recovering from a power loss, press the cancel button.