GETTING STARTED Power on/off To turn the power on Press the power on/off switch. The blue power indicator will blink quickly while the LAMP is preheating. After ten seconds (*1), the power indicator will stay on and the picture will start to appear. The picture will become normal after another 50 seconds. Temperature indicator When the set is on standby If the set is turned off by pressing the button on the remote control unit, the power indicator will become dark after two minutes slow blinking (lamp is cooling ) , then the set is entering standby mode ˈ indicating the TV is not turned off completely when it is in slight power consumption mode and waiting for your new command.
You can turn on the set using the button on the remote control unit in standby mode. The picture will appear after the power indicator quick blinking (the lamp is preheating). The picture will become normal in 50 seconds. You can also press the program CH +/- buttons on the front panel to turn on the set. * 1 With the special operation or something wrong occurs to the lamp, the blinking will prolong. To turn power off 1. Put the set in standby mode, first. Press the button on the remote control unit, the power indicator will become dark after two minutes slow blinking (lamp is cooling ), then the set will enter standby mode. 2. Then turn off the power.
Be sure that the power indicator becomes dark after slow blinking, then press the set power on/off switch to turn off the power. Notes :(1)Please follow the above steps to prolong the lamp life. Avoid turning off the power directly. (2)You can press the power on/off switch to cut the power supply directly in times of emergency only. (3)Failure to follow the correct operating and shutdown procedures may damage the lamp and void the warranty. Note : If you are not going to use the set for a long time, turn off the power on/off switch and disconnect the plug from the power outlet.
12 Power indicator 32:(5 7(03 /$03 Power on/off Lamp indicator switch Remote control sensor POWER indicator blink quickly Lamp is preheating blink slowly Lamp is cooling on(dark) On standby on(bright) Power on LAMP indicator on Lamp going out Please contact a service technician for inspection or repairing. blink Lamp’s door being opened TEMP indicator on Lamp overheating blink Fan stopping 32:(5 7(03 /$03