9845B/C Environmental, Installation, and Preventive Maintenance Requirements 2·13 FCC Radio Frequency Interference Statement I FEDERAL COMMUNICATIONS COMMISSION I RADIO FREQUENCY iNTERFERENCE I STATEMENT (U.S.A. ONLY) I The Federal Communications Commission (in Subpart J of Part 15. Docket 20780) has specified that the following I notice be brought to the attention of the users of this product. I Warning: This equipment generates. uses. and can radiate radio frequency energy ann if not installed and used in I accordance with the instructions manual. may cause interference to radio communications.
As temporarily permitted by regulation it has not been tested for compliance with the limits for a Class A computing device pursuant to Subpart J of Part 15 of FCC Rules. which are designed to provide reasonable protection against such interference. Operation of this equipment in a residential area is likely to cause interference in which case the user at his own expense will be required to take whatever measures may be required to correct the interference. Initiating Power Once the computer is set up properly, it is ready to turn on. Before you do, here are some things to check: Is the proper type of fuse installed? Is the proper voltage set? • Are the ROMs installed?
• Are the interfaces and peripherals connected? Next connect the power cord (two on the 9845C) to the power input connector on the rear panel of the mainframe (and CRT - 9845C). Plug the other end of the cord into an AC power outlet. SHOULD A SINGLE, BRIGHT, HORIZONTAL LINE APPEAR ACROSS THE CENTER OF THE CRT, IMMEDIATELY SWITCH THE COMPUTER OFF TO AVOID DAMAGE. CAUTION Now that the system is set up, set the power switch on the right side of the machine to the "1" position to turn it on. Set the CRT intensity using the knob under the front of the CRT. Loading Printer Paper The internal printer is an 80-character line printer used for hardcopy output.
Refer to the section entitled "Accessories Supplied" for part numbers of the types of paper. CAUTION HP SUPPLIED THERMAL PAPER IS FORMULATED SPE- CIFICALL Y TO WORK WITH THE SYSTEM 45 INTERNAL PRIN- TER. THERMAL PAPER FROM OTHER SOURCES MAY OR MAY NOT WORK WITH THE INTERNAL PRINTER AND, THEREFORE, HP IS NOT RESPONSIBLE FOR DAMAGES CAUSED BY USING NON-HP PAPER.