To access the software you must go to the Setup tab and to: Options , System , Service (this part is password protected, the password is ’ support ' Scantest . When the SCANtest 6 diagnostic software has been started, the Scanner is switched ON in Test Mode, and the Diagnostic LED on the Operator Panel is turned ON. Scanner Test Program Menu ● Test 1: Scanner Information ● Test 2: LED Test ● Test 3: Key Test ● Test 4: Original-Sensor Test ● Test 5: Lamp Test ● Test 6: Motor Test ● Test 7: Complete Hardware Test ● Test 9: Camera Adjustment ● Test 11: Stitching and Vertical Alignment ● Test 12: Adjust Y-Axis Scaling ● Test 13: Switch Scanner to Test Mode ● Test 20: Noise Test ● Test 21:
Scan Dump ● Test 27: Camera Adjustment Wizard ● Test 28: Original Guide Sensor Test ● Test 30: Calibrate ATAC ● Test 31: Driver Board Communication Test If SCANtest 6 is started when the scanner is in Error Mode, the Error Code Number and a short description of the error will be displayed on the screen. Test 1: Scanner Information This test displays general information regarding the scanner. When executed, the test displays the following: ● Scanner Model: ● Firmware Release: ● Firmware Release Date: ● Firmware Build: ● FPGA Revision: ● FPGA Release Date: ● Boot Code Revision: ● Boot Code Release Date: ENWW Using the SCANtest 6 Diagnostic Software 3