Removal and Installation Right Hand Cover Removal WARNING Switch off the Printer and remove the Power Cord. WARNING To remove the Right Hand Cover you must open the Right Cover door and push in the Printhead Cleaner Carriage. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Right Rear Cover - Refer to Page 8-16 . 2. Remove the Ferrite (if present) and disconnect the Front Panel cable from the Main PCA (P24) from the left side of the Electronics Module. P24 3. On the Main PCA, disconnect the Aerosol Fan cable from position P30 and the service station door from position P29. P29 P30 8-10 HP DesignJet 5000 and 5500 Series Printers Service Manual