Removal and Installation Media Sensor Removal WARNING Switch off the Printer and remove the Power Cord. 1. Remove the Top Cover - Refer to Page 8-5 . 2. Remove the Right Rear Cover - Refer to Page 8-16 . 3. Remove the Left Rear Cover - Refer to Page 8-15 . 4. Remove the Back Cover - Refer to Page 8-23 . 5. Remove the Electronics Module - Refer to Page 8-97 . 6. Remove the Lower Right EMC Cover - Refer to Page 8-32 . 7. Remove the Booster Fan for better access - Refer to Page 8-108 . 8. Reach under the Center Guide and carefully remove the Media Sensor mount by pulling it down gently (as shown below).
TIP Pull down the Media Sensor by inserting a finger on each side of the sensor and pulling down. 2. Pull down 1. Insert fingers 8-109 HP DesignJet 5000 and 5500 Series Printers Service Manual