Removal and Installation TIP To check correct functioning of serviced parts on the Printer axis you can do the following: a Reinsert the top T-15 screw ( Type F ) at the rear of the Printer. b Hang the Cover on the screw. c Connect all cables at the Rear of the Right Cover and turn on the Printer. Installation of Right Hand Cover NOTE Make sure the Front Panel cable and the Aerosol Fan cables are secured inside the Right Hand Cover with cable clamps and retaining pins. WARNING Make sure cables pass through slot at rear of chassis on the right hand side otherwise the Cover cannot be properly installed and cables may be damaged. 8-13 HP DesignJet 5000 and 5500 Series Printers Service Manual