Removal and Installation Right Hand Trim Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove Right Rear Cover - Refer to Page 8-16 . 2. Remove Right Hand Cover - Refer to Page 8-10 . 3. Remove Media Lever Assembly - Refer to Page 8-18 . 4. Disconnect the Sensors cable from position P27 on the Main PCA. P27 5. Remove 1 T-15 screws ( Type F ) and 1 T-20 ( Type L ) from the Right Hand Trim. 8-20 HP DesignJet 5000 and 5500 Series Printers Service Manual