Removal and Installation Trailing Cable Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Top Cover - Refer to Page 8-5 . 2. Remove the Right Rear Cover - Refer to Page 8-16 . 3. Remove the Right Hand Cover - Refer to Page 8-10 . 4. Remove the Left Hand Cover - Refer to Page 8-6 . 5. Slide the Carriage to the left side of the Printer. 6. Unclip and remove the Carriage Cover to access the Trailing Cable in the Carriage. 8-36 HP DesignJet 5000 and 5500 Series Printers Service Manual