Removal and Installation 2. Insert the Trailing Cable Guide into the Carriage and connect the Trailing Cables. NOTE Remember to pass the Trailing Cables through the Ferrite(s). 3 for 60" Model. 1 for 42" Model. 3. Insert the Trailing Cable through the Chassis slot next to the Trailing Cable Clip on the right (see diagram in step 4). Right Clip Slot 4. Place the Right Trailing Cable Clip in position and adjust the length of the Trailing Cable. NOTE This clip has a locating pin so make sure this is in position and the Trailing Cable is the right length before installing the screw. locating pin 8-40 HP DesignJet 5000 and 5500 Series Printers Service Manual