Removal and Installation Tensioner Assembly Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Left Hand Cover - Refer to Page 8-6 . 2. Remove the Right Hand Cover - Refer to Page 8-10 . 3. Remove the 5.5 mm nut from the left hand side of the Printer that attaches the Encoder Strip to the Spring Clip. TIP The next step is performed by putting pressure on the Spring Clip as shown. 4. Release the Encoder Strip from the retaining pin on the Spring Clip. 1. Apply Pressure 2. Release Encoder Strip 8-42 HP DesignJet 5000 and 5500 Series Printers Service Manual