Removal and Installation 12. Remove by sliding the Main PCA to the left and lifting out (see detail below). NOTE Detail of Main PCA removal. Installation of Main PCA NOTE When the Main PCA has been replaced, perform the Backup EEROM ⇒ Page 4-30 . NOTE If you replace the Main PCA and the HDD at the same time you must perform ALL Service Calibrations ( ⇒ Page 5-3 ) and the EEROM Setup Service Utility ( ⇒ Page 4-23 ) . NOTE If you are not sure how the cables are connected on the Main PCA, each connector is labelled with the name of the assembly to which it is connected.
NOTE When installing the Hard Disk Drive, please refer to the instructions for the installation of the PCI-to-IDE PCA (Refer to Page 8-86 ) and the installation of the HDD Cable (Refer to Page 8-87 ). 8-84 HP DesignJet 5000 and 5500 Series Printers Service Manual