Removal and Installation Ink Leak Detector - If Present (Only Applicable to the 5000 Series) Removal WARNING Switch off the Printer and remove the Power Cord. NOTE Refer to the table on Page 8-4 for information on screw types. 1. Remove the Left Rear Cover - Refer to Page 8-15 . 2. Remove the Top Cover - Refer to Page 8-5 . 3. Remove the Back Cover - Refer to Page 8-23 . 4. Disconnect the Ink Leak Detector cable at position P2 from the ISS PCA. P2 5. Remove one T-15 screw ( Type B ) to release the cable clip on the Top EMC cover. 8-93 HP DesignJet 5000 and 5500 Series Printers Service Manual