Transfer roller CAUTION: Do not touch the black rubber on the roller. Skin oils on the roller can cause print-quality problems. The use of disposable gloves is recommended when you remove the transfer roller. 1. Open the front cover. NOTE: If the print cartridge was not removed prior to servicing the prodcut, remove it now. 2. Use a transfer-roller removal hook (callout 1) to lift the left end of the metal shaft out of place near the blue gear (callout 2). If a removal hook is not available use a flatblade screwdriver. Slide the transfer roller to the left to remove it. CAUTION: Be careful to release and lift the left side of the roller first , and then slide the roller out. NOTE:
The transfer-roller removal hook is included with a transfer-roller replacement kit. Figure 2-9 Remove the transfer roller Reinstallation tip When you install the transfer roller, make sure that the black collar on the left side is oriented correctly, with the open end face-down (the solid end is face-up). ENWW Customer replaceable units (CRUs) 69