Reinsert duplexer ........................................................................... 483 Remove one toner cartridge ........................................................... 483 Remove USB accessory ................................................................. 483 Replace .......................................................................... 483 Resend external accessory firmware ............................................. 484 Replace supplies ............................................................................ 484 Resend Upgrade ............................................................................
485 Restore Factory Settings ................................................................ 485 ROM disk device failed To clear touch “OK” .................................. 485 ROM disk file operation failed To clear touch “OK” ........................ 485 ROM disk file system is full To clear touch “OK” ............................ 485 ROM disk is write protected To clear touch “OK” ........................... 485 ROM disk not initialized To clear touch “OK” .................................. 486 Rotating Motor ................................................................................ 486 Size mismatch in Tray .............................................................
486 Sleep mode on ............................................................................... 486 Staple Cartridge 2 and 3 very low (warning) .................................. 486 Staple Cartridge low (warning) ................................................ 487 Staple Cartridge low ....................................................................... 487 Stapler/Stacker staple jam .............................................................. 487 Supplies low ................................................................................... 487 Supply Memory Warning ................................................................
487 The unit has corrupt data ................................................................ 487 Too many pages in job to staple ..................................................... 488 Too many pages to make booklet .................................................. 488 Tray [type] [size] ...................................................................... 488 Tray empty: [Type], [Size] ....................................................... 488 Tray lifting ............................................................................... 489 Tray open ................................................................................
489 Tray overfilled ......................................................................... 490 Type mismatch Tray ............................................................... 490 Unsupported drive installed To continue, touch “OK” ..................... 490 Unsupported supply in use OR Unsupported supply installed To continue, touch “OK” ....................................................................... 491 Unsupported tray configuration ...................................................... 491 Unsupported USB accessory detected Remove USB accessory ... 491 Upgrade Error .................................................................................
491 Upper left bin full ............................................................................. 491 USB accessory not functional ......................................................... 492 USB hubs are not fully supported Some operations may not work properly ........................................................................................... 492 xx ENWW