Rear cover and fuser cover NOTE Some photos show a device other than the HP LaserJet M1005 MFP. Repair and replacement procedures in this chapter are for the HP LaserJet M1005 MFP and are not affected by cosmetic differences (for example, the color of the covers) shown in these photos. 1. Remove the right-side and left-side covers. See Device side covers on page 82 2. Remove one screw (callout 1). Figure 6-40 Remove the rear cover and fuser cover (1 of 3) 3. Release the two rear-cover locking tabs (callout 2). Rotate the bottom of the rear cover up and away from the device, and remove it. Figure 6-41 Remove the rear cover and fuser cover (2 of 3) 86 Chapter 6 Removal and replacement ENWW