5. Disconnect one FFC (callout 4) from the power supply. CAUTION Do not bend or fold the FFCs during the removal or reinstallation process. Figure 6-59 Remove the ECU (4 of 6) 6. Disconnect one FFC (callout 5) from the ECU and the wire-harness connector to the main motor (callout 6). Remove one screw (callout 7). Release the wire-harness (callout 8) from the retainer slot on the ECU. Tip Unweave this wire-harness from additional wire looms to have enough slack to disengage it from the slot on the ECU. Figure 6-60 Remove the ECU (5 of 6) 100 Chapter 6 Removal and replacement ENWW