Fuser 1. Remove the following assemblies. ● Scanner assembly. See Scanner assembly on page 67 . ● Left cover. See Device side covers on page 82 . ● Rear cover and fuser cover. See Rear cover and fuser cover on page 86 . ● Print cartridge door. See Print-cartridge door on page 85 . ● Front cover. See Front cover on page 88 . ● Scanner support frame and chassis reinforcement plate. See Scanner support frame on page 95 . 2. Disconnect cables from near the top of the engine power assembly and disconnect the large grounding wire from the back of the device. 3. Disengage the wire-harnesses from the wire retainers to release the fuser assembly. 4.
Remove three screws (callout 1; this figure shows the delivery-sensor PCB removed, which is not necessary). Figure 6-65 Remove the fuser assembly (1 of 2) ENWW Removal and replacement strategy 105