HP — Networking and I/O

Table 2-10 Jetdirect menus (continued) Menu item Submenu item Submenu item Values and Description Manual : Use the Manual Settings menu to configure TCP/IPv4 parameters. DHCP Release This menu appears if Config Method was set to DHCP and a DHCP lease for the print server exists. No (default): The current DHCP lease is saved. Yes : Release the current IP address. Note that the printer will lose network connectivity until it reboots at which point it may have a new address. DHCP Renew This menu appears if Config Method was set to DHCP and a DHCP lease for the print server exists. No (default): The print server does not request to renew the DHCP lease. Yes :

The print server renews the lease on its IP address. Manual Settings (Available only if Config Method is set to Manual ) Configure parameters directly from the printer control panel: IP Address : The unique IP address of the printer (n.n.n.n), where n is a value from 0 to 255. Subnet Mask : The subnet mask for the printer (m.m.m.m), where m is a value from 0 to 255. Syslog Server : The IP address of the syslog server used to receive and log syslog messages. Default Gateway : The IP address of the gateway or router used for communications with other networks. Idle Timeout :

The time period, in seconds, after which an idle TCP print data connection is closed (default is 270 seconds, 0 disables the timeout). Default IP Specify the IP address to default to when the print server is unable to obtain an IP address from the network during a forced TCP/IP reconfiguration (for example, when manually configured to use BootP or DHCP). Auto IP : A link-local IP address 169.254.x.x is set. Legacy : The address 192.0.0.192 is set, consistent with older HP Jetdirect devices. Primary DNS Specify the IP address (n.n.n.n) of a Primary DNS Server. Secondary DNS Specify the IP address (n.n.n.n) of a Secondary Domain Name System (DNS) Server.

IPV6 Settings Enable Use this item to enable or disable IPv6 operation on the print server. Off (default): IPv6 is disabled. On : IPv6 is enabled. ENWW Use the Administration menu 27