Table 2-10 Jetdirect menus (continued) Menu item Submenu item Submenu item Values and Description Ping Results Use this item to view the ping test status and results using the control panel display. You can select the following items: Packets Sent Shows the number of packets (0 - 65535) sent to the remote host since the most recent test was initiated or completed. Packets Received Shows the number of packets (0 - 65535) received from the remote host since the most recent test was initiated or completed. Percent Lost Shows the percent of ping test packets that were sent with no response from the remote host since the most recent test was initiated or completed.
RTT Min Shows the minimum detected round-trip time (RTT), from 0 to 4096 milliseconds, for packet transmission and response. RTT Max Shows the maximum detected round-trip time (RTT) from 0 to 4096 milliseconds for packet transmission and response. RTT Average Shows the average round-trip-time (RTT), from 0 to 4096 milliseconds for packet transmission and response. Ping In Progress Shows whether a ping test is in progress. Yes indicates a test in progress, and No indicates that a test completed or was not run. Refresh When viewing the ping test results, this item updates the ping test data with current results. Select Yes to update the data, or No to maintain the existing data.
However, a refresh automatically occurs when the menu times out or you manually return to the main menu. Link Speed The link speed and communication mode of the print server must match the network. The available settings depend on the product and installed print server. Select one of the following link configuration settings: CAUTION: If you change the link setting, network communications with the print server and network device might be lost. Auto (default): The print server uses auto-negotiation to configure itself with the highest link speed and communication mode allowed.
If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.) 10T Half : 10 Mbps, half-duplex operation 10T Full : 10 Mbps, full-duplex operation 100TX Half : 100 Mbps, half-duplex operation 100TX Full : 100 Mbps, full-duplex operation 100TX Auto : Limits auto-negotiation to a maximum link speed of 100 Mbps. 32 Chapter 2 Control panel ENWW