Novell Networks -23 I/O Not Readv Coniiguratin TroubLeshootin~Pi’ocedure One of tie most common problems the CE will encounter when ~ LaserJets are mnnected to Novell n-orks is” 23 1/0 NOTREADY”. On most occasions tiproblem~ NOT A H~WARE FAULT andthe NetworkA~ator shotidbe ableto correct. Notiythisisa co-ationprobl~ thatistheJe~ect card(Installedrn Optional I/O slot) is not reco~ed by the network. Note it is tie responsii~ of the N*ork Administrator to configure JetDirect boards into network. The foJlowing steps should be adopted to check ifthe Novell n~ork reco@es the JetDirect card Note: Then~orkA_ator nmst have overall responsibii and must be present dtig this procedure.
Obtain COPY Of No@ Press button on JetDirect car~ this is located on this Status Page cards face-plate. See Status page on oposite page. Note Look for I/O NOT READY(xx) on Status page. Sub error (x) shotidbe crosreferenced. ThiswillgivereasonforUO Not Ready (i.e. 16= Not Configured).Tkis information N can be found m tke HP JetJ)irect Network ~ con.figuration guide. See Statuspage opposite. Note Off Status page take a note oftke Mode Address (Hard- Jet13ir-Hard- ware address)wkich is sirnilarto this 080009171812. ware address ~is Mode Address is unique to emh JetDirmt. See Statuspage opposite.
B~g up Note With NetworkAdministrator bring up HP Untility JetAdmir JetAdmin Go into “con6guration “menu. Bring up screen which shov utility alIJetDirect cards connected en the network. Note: JfHardware address does appear get Network a~atol to contignre on to network using JetAdmin. If not: 1. Try LaserJet on another part ofnetwork. 2. Check network cabling. 3. Lastly replace JetDirect board. \ / / 1-17