Removal and replacement procedures Rollers Pick roller CAUTION: Do not touch the spongy roller surface unless you are going to replace the pick roller. Human skin oils that contact the pick roller can cause paper pickup problems. 1. Use the following procedures to rotate the pick roller into the position required to remove it. LCD control panel (HP LaserJet Pro 200 color M251n Printer) ● Open the Secondary Service menu by pressing and releasing the Left arrow ( ) and then quickly pressing the Cancel button. ● Use the arrow buttons to select Pick roller , and then press the OK button. ● Press the OK button again to confirm that you want the pick roller to rotate.
● Remove the power cord, without turning off the power using the power switch, and then remove the interface cable. NOTE: If the power to the product is turned off using the power switch, the pick roller will rotate to the parked position. Touchscreen control panel (HP LaserJet Pro 200 color M251nw Printer) ● Touch the Setup button. ● Touch the middle of the screen along the left edge (callout 1), and then immediately touch the lower-right corner (callout 2) of the screen. 1 2 ● When the Home screen appears, touch the Setup button again. ● Touch the 2ndary Service button. ● Touch the arrow buttons (at the right or left side of the touchscreen) until the Pick Roller button appears.
● Touch the Pick Roller button. 8 Chapter 1 Removal and replacement ENWW