Cartridge door and front cover assembly NOTE: The cartridge door assembly includes the cartridge door, Tray 1, and the front cover. 1. Remove the following components: ● Tray 2 cassette ● Right cover. See Right cover on page 12 . ● Left cover. See Left cover on page 11 . 2. Open the toner cartridge door and the rear jam access door. 3. Disconnect one connector (callout 1), and then release two tabs in the pivot joint (callout 2) to disengage the cartridge-door assembly link arm (callout 3). TIP: The link arm releases the fuser-pressure lever when the cartridge door is opened.
Figure 1-28 Remove the cartridge door assembly and front cover (1 of 4) 2 1 3 ENWW Removal and replacement procedures 23