3. On the left side of the product, remove the ground-wire screw (callout 1), disconnect one wire connector (callout 2) on the formatter, and disconnect two flat, flexible cables (callout 3) on the formatter. Figure 1-17 Remove the scanner assembly (1 of 2) 1 2 3 Reinstallation tip Do not lose the two protective guides installed on the flat, flexible cables. Be sure to reinstall them when you reinstall the scanner assembly. 4. At the rear of the product, remove four screws (callout 1), and then slide the scanner toward the rear of the product to remove the assembly. Figure 1-18 Remove the scanner assembly (2 of 2) 1 NOTE:
The four scanner assembly screws removed in this step are a different size than the other screws used on the product. Set these screws aside to use when you reinstall the scanner assembly. 14 Chapter 1 Removal and replacement ENWW