4. At the rear of the product, remove five screws (callout 1), release one tab (callout 2) near the bottom corner, and release two tabs (callout 3) from under the top cover assembly. Figure 1-27 Remove the rear cover, rear door, and feed assembly (2 of 3) 3 1 2 5. Carefully separate the rear cover and rear door from the product, and then remove them. NOTE: The duplex-paper-feed assembly is removed with the cover and door Reinstallation tip When you reinstall the rear cover assembly, open the rear door to make sure that the rear cover fits even against the product chassis before you install the mounting screws. 6. There are two hinge pins (callout 1).
Release the shorter left pin first, and then separate the rear cover and rear door assembly (callout 2) from the duplex-paper-feed assembly (callout 3). Figure 1-28 Remove the rear cover, rear door, and feed assembly (3 of 3) 2 3 1 ENWW Removal and replacement procedures 21