Removal and replacement procedures Pickup roller You might have to rotate the pickup roller to gain access to the roller locking tabs. 1. Remove the input tray and tilt the product back until the pickup roller is visible. If the locking tabs on each side of the roller are not accessible, use the following procedure in this step to rotate the roller and access the tabs. If the tabs are visible, proceed to the next step. a. Reinstall the input tray, and then turn the product on. b. Touch the Setup button. c. Touch the middle of the screen along the left-hand edge (callout 1), and then immediately touch the lower-right corner (callout 2) of the screen. 1 2 d.
When the Home screen appears, touch the Setup button again. e. Touch the 2ndary Service button. f. Touch the arrow buttons (at the right- or left-side of the touch screen) until the Pick roller button appears. g. Touch the Pick roller button. h. Touch the OK button to confirm that you want the pick roller to rotate. i. Turn the product power off, and then remove the power cord and the interface cable. 2. Carefully place the product front-side up. CAUTION: The document-feeder and scanner cover are not captive and can open suddenly if the product is placed front-side up. Always support the document-feeder and scanner cover before placing the product front-side up. NOTE:
Debris can scratch or damage the back of the product. Before you place the product front-side up, remove any debris from the work surface. If possible, set the product on a clean, dry cloth to prevent scratching and damage. 8 Chapter 1 Removal and replacement ENWW