Separation roller CAUTION: Do not touch the spongy roller surface unless you are going to replace the roller. Skin oils on the roller can cause paper pickup problems. 1. Remove paper tray (if installed), and then carefully place the product front-side up. CAUTION: The document-feeder and scanner cover are not captive and can open suddenly if the product is placed front-side up. Always support the document-feeder and scanner cover before placing the product front-side up. NOTE: Debris can scratch or damage the back of the product. Before you place the product front-side up, remove any debris from the work surface.
If possible, set the product on a clean, dry cloth to prevent scratching and damage. 2. Carefully release the roller cover and rotate it down and away from the roller. Reinstallation tip Make sure that this cover snaps into place over the roller when the roller and holder are reinstalled. Figure 1-4 Remove the separation roller (1 of 2) 10 Chapter 1 Removal and replacement ENWW