2. Remove four screws (callout 1), the scanner cover (callout 2) and the sheet-metal plate (callout 3). NOTE: The scanner cover and plate are removed as one assembly. TIP: When the cover is reinstalled, make sure that the black screws (callout 4) are installed in the correct screw holes. Figure 2-55 Remove the main motor (2 of 7) 4 1 2 3 3. Release two tabs (callout 1), and then slightly separate the motor driver PCA (callout 2) from the product. CAUTION: The motor driver PCA is still connected to the product by the wire harnesses and a FFC. Figure 2-56 Remove the main motor (3 of 7) 1 2 ENWW Main assemblies 73