2 Removal and Replacement This chapter tells you how to remove and replace the Omnibook’s removable components and assemblies. The items marked by • in the following table are user-replaceable. Table 2-1. Removal Cross-Reference • Battery, main (page 2-4). Battery, CMOS (page 2-34). • Bumpers, display (page 2-12) • Cap, pointing stick (page 2-12). • Card, mini-PCI #1 (page 2-9). Card, mini-PCI #2 (page 2-34). Case, bottom (page 2-22). Case, top (page 2-20). Cover, center hinge (page 2-34). • Cover, left corner (page 2-12). Cover, left hinge (page 2-34). • Cover, mini-PCI (page 2-12). • Cover, SDRAM (page 2-12). • Cover, right corner (page 2-12). Cover, right hinge (page 2-34).
• Covers, screw (page 2-12). CPU module (page 2-19). Display assembly (page 2-12). Doors, docking (page 2-27). Doors, PCMCIA (page 2-27). • Drive, hard disk (page 2-7). • Feet, rubber (page 2-12). Heatsink (with fan) (page 2-17). Keyboard (page 2-15). Panel, sound/IR (page 2-34). Panel, mini-PCI (page 2-34). • Panel, power button (page 2-11). Panel, vent (page 2-34). PCA, display interface (page 2-34). PCA, power supply (page 2-34). PCA, motherboard (page 2-22). PCA, volume (page 2-34). PCA, front antenna (page 2-34). PCA, rear antenna (page 2-34). • Plug-in module (page 2-5). • SDRAM module (page 2-6). Socket, PCMCIA (page 2-34). Speaker assembly (page 2-28).
• Tray, hard disk drive (page 2-7). Caution Always provide proper grounding when performing repairs. Without proper grounding, an electrostatic discharge can damage the Omnibook and its components. Notes Reassembly steps are the reverse of the removal steps. Reassembly notes are included at the end of each section below. Symbols like this throughout this chapter show approximate full-size screw outlines. You can use these to verify the sizes of screws before you install them. Installing a wrong-size screw can damage the unit. (The symbol at the left represents an M2.5Ч5mm T-head screw.) HP Omnibook 6000/6100 Removal and Replacement 2-1